Coaxial Cable Stripper
- Add Product to Favorites
- Add Company to Favorites
Product Details:
| Model Number | NT-001 |
|---|---|
| Minimum Order Quantity: | 1000 Piece/Pieces |
| Packaging Details: | 1000 pcs/carton |
Detailed Product Description
Coaxial Cable Wire Stripper
3-Blades Model ( RG58/59/6)
Built-inhex key to adjust the blade
For stripping different materials
INSTRUCTIONS
- Use thumb to press the jaws open.
- Insert coax. Cable through V-block to have the coax. Cable reach cable guide level. Release thumb to close jaws.
- Insert the index finger through the hollow then turn the coax. Cable stripper on clockwise by 5-6 times.
- Open jaws again, take cable out and remove the outer jacket, shield and dielectric so that the inner conductor is exposed. Thus, completing the operation.
- Snap out the built-in hex key wrench and insert it into hex socket to align blades to fit your coax. Cable size. Turn clockwise to minimum of cable 4mm cable dia. and counter –clockwise to maximum 10mm cable dia.
- V-block is reversible (HT-312A for RG-6,59,62, HT-312B for RG-58t59,62). Use hex key wrench to push the V-block out of the stripper, reverse the V-block and insert it into the stripper at original location.
- Blades have been pre-set for the indicated sizes on the V-block. However there, are many different sizes of cable, If you find the stripper doesn’t fit your cable sizes adjust the blades by process No6 to meet your cable sizes.
